DCD DESIGN AND MANUFACTURING LTD 00620-300

Overview

Product Description

DCD DESIGN/CABLE SPINNING EQUIPMENT 00620-300 Duct Puller 3" Duct NEW These products are designed to grip polyethylene ducting using expanding jaws to grip the inside wall of the duct. This causes the pulling load to be spread around the circumference of the duct and allows a maximum load to be applied without damage to the ducting. Care should be taken at all times not to exceed the yield value of the ducting since this may cause permanent deformation to the duct as well as loss to the integrity of the polyethylene. On thin wall ducting, it is recommended that an outer duct sleeve be used to prevent the duct stretching during installation. A firmer and more stable grip will also be obtained when this is done. Use of a duct plugger will help to prevent mud and slurry from entering past the puller into the ducting. Duct wall thickness is normally designated by an SDR value. The lower the SDR value, the heavier the wall thickness. These products can be used on SDR 11 through SDR 17 ducting.

Product Videos

Custom Field

Product Reviews

Write a Review

DCD 00620-300 Duct Puller 3" Duct NEW